#TRIGGERcmd

The TRIGGERcmd integration allows you to run commands on computers via TRIGGERcmd with Home Assistant.

#Prerequisites

To use TRIGGERcmd, you need the following:

• A TRIGGERcmd account
• A computer with the TRIGGERcmd agent running on it
• For instructions on installing and using TRIGGERcmd itself, refer to the TRIGGERcmd Quick Start Guide.
• After adding the TRIGGERcmd integration, you will be prompted for your user token. This can be found at the bottom of your TRIGGERcmd profile page or the instructions page.

#Using TRIGGERcmd with Home Assistant

All of your TRIGGERcmd commands should show up as switch devices. You can change the rooms of your devices, or select Finish to leave them without rooms.

Using the switch will trigger the respective command. If you have Allow parameters enabled, your command will run with an "on" or "off" parameter, depending on whether you flip the switch in Home Assistant on or off.